3/22/2021 0 Comments Putty Display Hex
A user can configure whether the current buffer scrolls down when the screen is clear.If you enables the back wrap, the cursor at the beginning of a line moves back to the end of previous line when a BS character is received.To enable the back wrap, edit the BackWrap line in the Tera Term section of the setup file like the following.Tera Term will sound the beep when the BEL character(ASCII 07) receives.
You can disable the beep sound for the BEL character by editing the Beep line in the Tera Term section of the setup file like the following. Also, the terminal screen will flush instead of sounding the beep in the following configuration. If you choose the Terminal ID to be VT2XX or VT3XX in the Setup Terminal dialog box, characters in range of ASCII 80-9F are interpreted as the C1 control characters. You can disable this interpretation and make these characters visible on the screen (if you are using a font which supports these characters), by editing the Accept8BitCtrl line in the Tera Term section of the setup file like the following. When sending C1 control characters, Tera Term uses equivalent 7-bit sequences. To send C1 control characters as single 8-bit characters, edit the Send8BitCtrl line in the Tera Term section of the setup file like the following. Host can change this setting by S7C1T S8C1T DECSCL control sequence. To display all received characters (including control characters) on the screen, edit the Debug line in the Tera Term section of the setup file like the following. If you press ShiftEsc, Tera Term enters the debug mode, in which all received characters are displayed on the screen. The debug mode have four pattern, a user can switch from output as usual to disable output completely. If you select the output as usual in the debug mode, Tera Term returns to the normal mode. In the debug mode, received characters are displayed by the following way. In the hex output mode, received characters are displayed by the following way. Then, escape sequences for the status line functions are ignored. In TEK GIN mode, the cross hair cursor appears in the TEK window. When you press a key or click the left mouse button, the key code (ASCII code) is sent with the coordinate of the cursor. You can change the key code for the left mouse button by editing the TEKGINMouseCode line in the Tera Term section of the setup file like the following. If you set on, the behavior of tab at end-of-line is the same as VTPuTTYxterm. If you set off, the behavior of tab at end-of-line is the same as FreeBSD console(syscons). The tab causes automatic linefeed. VT).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |